Heat Of Compression Dryer

The Heat Of Compression Dryer is an industrial product manufactured in India and is available in various sizes. Its sleek silver color makes it aesthetically pleasing and suitable for any industrial environment. This dryer has been specifically designed to remove the moisture present in compressed air, making it an essential tool for any industrial setup. The warranty provided adds to the reliability and trustworthiness of this product.

This type of dryer has virtually negligible operational cost as compared to other dryers. It is again a no loss type and no heater is required for regeneration. In fact the hot air  coming out from the compressor itself is sufficient for the regeneration. But the minimum temperature should be 120 deg C. This temperature is not possible for smaller capacity compressor , hence HOC type dryer is for larger capacity. This dryer is always installed near the compressor so as to use maximum heat. In this dryer, first of all the hot air from the compressor enters into one column and picks up the moisture of the desiccant and knocks down its moisture after getting it cooled in a cooler and then it enters into the second column for drying. The cycle repeats after pre set intervals. These dryers are most ideal for larger capacities beyond 500 Nm3/hr and for the application where  dew point i(-) 40 deg C is enough. 

Specifications

• Capacity -  500 to 15,000 Nm3/hr
• Pressure -  5 to 16 Bar (g) standard . ( Higher Pressure on demand)
• Pr.Dew Point -  (-) 40 deg C

High Pressure, Low Pressure Gas Dryer

Under this category Calorie HNT has a specific design and the systems are made as per the individual customers requirement. The specification under this category 

Specifications

• Capacity -  50 to 10,000 Nm3/hr
• Pressure -  0.5 to 300 Bar (g) 
• Pr.Dew Point -  (-) 20 deg C to (-) 80 deg C

MEMBRANE DRYER

A tube is filled with hollow membranes that allow compressed air to pass but remove water vapor. These dryers give a -80 deg F dew point relative to the incoming air temperature. Membrane dryers have NO MOVING PARTS and require NO ELECTRICITY & MAINTENANCE, and therefore have a very long life. It occupies 1/10th of the space as compared to other dryers. There are many model of the membrane module which depends upon its size and capacity. A combination of many such modules enhance the capacity and dew point.

Specifications

• Capacity -  5 to many million  Nm3/hr
• Pressure -  5 to 14 Bar (g) standard 
• Dew Point -  (-) 20 deg C to (-) 40 deg C